Setting of Baffle, Bubbler and Hose

<< Click to Display Table of Contents >>

Navigation:  Getting Started > Defining Injection Molding Components in SYNC > Cooling System >

Setting of Baffle, Bubbler and Hose

Users can only define sketch line or curve as hose, bubbler, or baffle. Solid entities are not supported.

? Note: Solid entities can be supported as cooling channels.

 

Select Baffle, Bubbler or Hose from the cooling channel type pull down menu.

 

Baffle

Refer to the picture on the left and set the related parameters

 

Bubbler

Refer to the picture on the left and set the related parameters

 

Hose

Set the diameter of the hose

Hose should be placed beyond the mold base boundary

Notice 1: During analysis, the cooling channel beyond mold base will be regarded as hose automatically.

 

clip0144

Notice 2: During analysis, the hose within mold base will be regarded as cooling channel.

 

clip0145

Click OK to confirm your settings.