Melt Entrance Wizard

<< Click to Display Table of Contents >>

Navigation:  Getting Started > Defining Injection Molding Components in SYNC > Melt Entrance >

Melt Entrance Wizard

You can start auto melt entrance command in the tool menu below the Moldex3D tab.

? Note: Melt Entrance Wizard can only be used on the runner defined by lines or runner wizard.

 

Click  to start Melt Entrance Wizard. After clicking it, the command will automatically add melt entrances to the runner system.

? Note: Although the melt entrance can be set on the gate directly. It is not recommended to set melt entrance without runner system, for it will influence simulation accuracy.

 

clip0132